What are the effects of using acidic zinc plating additives in the production process if the workpiece falls into the plating tank and is not picked up?

2026-11-18 09:45:15

What impact will it have if the workpiece falls into the plating tank and is not promptly salvaged during the production process of acidic zinc plating additives?

During the production process, if the workpiece falls into the galvanizing tank and is not promptly removed, it can cause an increase in iron impurities in the plating solution. At this point, Fe2+, Fe (OH)+, Fe3+, Fe (OH) 2+, etc. will form complexes with some plating solution components with coordination ability, increasing the consumption of acidic zinc plating additives in the plating solution.

acidic zinc plating additives

Especially Fe3+ions are prone to form flocs in the plating solution, which not only increases the resistance of the plating solution, increases the groove pressure, prevents the current from rising, but also slows down the deposition rate of zinc plating on the workpiece; Moreover, these flocculent substances will adsorb a large amount of brightener additives from the plating solution, which is the main reason for the high consumption of brightener components in the production process.

These workpieces that fall into the galvanizing tank dissolve in the tank, making it easy for iron impurities in the plating solution to oxidize and form Fe (OH) 3 suspensions and sediments when the content is above 500mg/L, which adhere to the surface and inner cavity of the workpiece and directly affect the effectiveness of the additive. The brightness of the coating appearance will decrease, and the thickness of the galvanized layer and the quality of the passivation film on the workpiece will also decrease. This is also the reason for the deterioration of the appearance quality and corrosion resistance of the workpiece.

Therefore, in the production process of using acidic zinc plating additives, we should promptly salvage the workpieces that fall off the galvanizing tank to reduce the occurrence of faults.